Many people have garage door openers around their homes for the convenience and security they provide. But what happens if you move into a new home and the garage door code doesn’t work? Or if you’ve lost the remote? Don’t worry – changing the code on a BFT garage door opener is a relatively simple process that can be done in just a few minutes.
First, you’ll need to locate the control panel for your garage door opener. This is usually found on the ceiling of your garage, near the motor. Once you’ve found the control panel, open it up and look for the “Learn” button. This button is usually located near the top of the control panel, and it may be labeled with an icon of a remote control.
When you press the “Learn” button, the garage door opener will enter “learn mode.” This means that it is ready to learn a new code from a remote control. Now, press the button on the remote control that you want to use to open your garage door. The garage door opener will beep once to indicate that it has learned the new code. You can now close the control panel and test the new code by pressing the button on the remote control. The garage door should open.
Saving the New Code
Once you have entered the new code into the control unit, it’s crucial to save the changes to ensure that the new code takes effect. Here’s a detailed guide on how to save the new code on a BFT garage door control unit:
1. Press the SET Button
Locate the SET button on the control unit. This button is typically clearly labeled or indicated with a specific symbol. Once you identify the SET button, press and hold it for a few seconds until the LED indicator light on the control unit starts blinking.
2. Enter the New Code Again
While holding down the SET button, re-enter the new code that you wish to program using the numeric keypad. Enter the code twice to confirm it.
3. Release the SET Button
After entering the new code twice, release the SET button. The LED indicator light should stop blinking and remain steady, indicating that the new code has been saved successfully.
4. Test the New Code
To verify that the new code works correctly, try entering it into the keypad on the exterior of the garage door. If the door opens smoothly, the new code has been programmed successfully.
5. Exit the Programming Mode
Once you have saved the new code and tested its functionality, you can exit the programming mode by following these steps:
| Step | Action |
|---|---|
| 1 | Press and hold the SET button for a few seconds. |
| 2 | Enter the factory code (usually “0000”). |
| 3 | Release the SET button. |
The control unit will return to its normal operating mode, and the new code will be active for future use.
How to Change Codes on a BFT Garage
To change the codes on a BFT garage, you will need the original remote control that came with the garage door opener. You will also need a new remote control or keypad to program with the new code. Here are the steps on how to change the codes on a BFT garage:
- Press and hold the “Learn” button on the garage door opener unit for 5 seconds. The LED light on the unit will start to flash.
- Press the button on the new remote control or keypad that you want to program. The LED light on the unit will stop flashing and turn solid.
- Release the button on the new remote control or keypad.
- The new code is now programmed into the garage door opener unit.
People Also Ask About How to Change Codes on a BFT Garage
How do I reset the code on my BFT garage door opener?
To reset the code on your BFT garage door opener, you will need to press and hold the “Reset” button on the unit for 10 seconds. The LED light on the unit will start to flash. Release the “Reset” button and the code will be reset to the factory default.
How do I program a new remote control to my BFT garage door opener?
To program a new remote control to your BFT garage door opener, you will need to follow the steps outlined in the “How to Change Codes on a BFT Garage” section above.
